Filter
Top Products
DISPLAY
POWER
• To turn the air conditioner ON, push this button. To
turn the air conditioner OFF, push the button again,
• This button takes priority over any other buttons,
• When you first turn it on, the unit is in cool mode,
High fan speed, Temperature setting at 72°F
REMOTECONTROLS GNALRECEIVER
j- MODE
- Every time you push this button, itwill shift among
COOL, ENERGY SAVER and FAN
- ENERGY SAVER
• The fan stops when the compressor stops cooling,
Approximately every 3 minutes the fan will turn on and
the unitwilt check the room air to determine if cooling is
needed,
FAN SPEED
•Everytimeyoupushthisbutton,it advancesthe
settingasfollows: {HIGH(F3)-, LOW(F1)
MED(F2)-, HIGH(F3)}
TEMPERATURE SETTING
• Usethis button to automatically contro_the
temperature of the room. The temperature can be
set within a range of 6O°Fto 86"F by increments of
I°F.
-9 ¥:IIil:oJ_"Jf:!_L "I
When power is restored after an
electrical power failure, the unit will begin
to run at its last setting.
]
AIR DIRECTION ADJUSTMENT
HORIZONTAL AIR DIRECTION CONTROL
The horizontal air direction is adjusted by moving
the vertical louvers right and left with your
fingertips, (FIG. 13)
TIMER
- SHUT-OFFTIME
• You will usually use shut-off time while you sleep.
• With unit running, use Timer to set number of hours until
shut-off.
• For your sleeping comfort, once Time is set, the
Temperature setting wilt raise 2+Fafter 30 rain., and
2°F after another 30 mm.
• Every time you push Timer button, it advances the Timer
setting as follows: 1 Hour • 2 Hours • etc. * 12 Hours
maximum
- START TIME
• With unit not running, use Timer to set number of hours
before unit starts.
• Every time you push Timer button, it advances the Timer
setting as follows: 1 Hour * 2 Hours * etc. + I2 Hours
maximum
VERTICAL AIR DIRECTION CONTROL
The vertical air direction is adjusted by moving the
horizontal Iouvers up and down with your fingertips.
(FIG. 14)
FIG. 13
1 -
FIG. 14