Filter
Top Products
REMOTE CONTROL
Note: The Remote Control wilI not operate properly if
strong light shines on the sensor window of the Air
Conditioner or if there are obstacles between the Remote
Control and the Air Conditioner.
Every time you push button, you will hear beep sound
from the Air Conditioner.
1 6 3
4 2 5
5
5, TIMER
- SHUT-OFF TIME
• You will usually use shut-off time while you sleep.
• With unit running, use Timer to set number of hours
untiI shut-off.
• Foryour steeping comfort, once Time is set, the
Temperature setting will raise 2F after 30 min, and
2°F after another 30 min.
• Every time you push Timer button, it advances the
Timer setting as follows: 1 Hour _ 2 Hours _ etc.
12 Hours maximum.
- START TIME
• With unit not running, use timer to set number of
hours before unit starts.
• Every time you push Timer button, it advances the
Timer setting as follows: 1 Hour _ 2 Hours _ etc.
12 Hours maximum
HOW TO INSERT BATTERIES
INTO REMOTE CONTROL
1. Removethe cover from the back of the remotecontroller.
2. Inserttwo batteries
• Besure that the (+) and (-) directions are correct
• Besure that both batteries are new
3. Re-attach the cover
FIG. 15
REMOTE CONTROL OPERATIONS
1. POWER
• To turn the air conditioner ON, push this button.
To turn the air conditioner OFF, push the button
again.
• This button takes priority over any other button
• When you first turn it on, the unit is in cool mode, High
fan speed, Temperature setting at 72T
2. TEMPERATURE SETTING
• Use this button to automatically control the
temperature of the room.
The temperature can be set within a range of 60°F to
86"F by increments of I°F.
3. MODE
- Every time you pushthis button, itwill shift among
COOL, ENERGY SAVER and FAN.
- ENERGY SAVER
• The fan stops when the compressor stops cooling
Approximately every 3 minutes the fan will turn on and
the unit wilt check the room air to determine if cooling
is needed
4. FAN SPEED
• Every time you push this button, it advances the setting
as follows: {High(F3) _ Low(F1) _ Med(F2) _ High(F3)}
-12-
'_ .16
• Do not use rechargeable batteries. Such batteries
differ from standard dry cells in shape, dimensions, and
performance.
• Remove the batteries from the remote controller if the air
conditioner is not going to be used for an extended
length of time.
• tnorder to prevent discharge, remove the batteries from
the remote control if the air conditioner is not going to be
used for an extended period of time. Keep the remote
control away from extremely hot or humid places. To
maintain optimal operation of the remote control, the
remote sensor should not be exposed to direct sunlight.
• The remote controI can be mounted on a wall using the
mountable holder.
,)
FIG. 17