Filter
Top Products
Extension Table
oDetaching the table
Pull the table away from the machine, as illustrated, for
"free-arm " sewing of cuffs and sleeves.
° Attaching the table
Push the extension table until it snaps into the machine.
(_ Extension table
(_ Pin
Holes
_._Tab
(_ Free-arm
Changing Needle
(_ Needle clamp screw
(_ Needle clamp
[_Turn off the power switch.
Raise the needle to its highest position by turning the
handwheel counterclockwise, toward you, and lowering
the presser foot. Loosen the needle clamp screw(_ by
turning it counterclockwise° Remove the needle from the
needle clamp (_.
[] Insert a new needle into the needle clamp(_)with the
flat side to the rear. When inserting the needle into the
needle clamp (_, push it up as far as it goes..Tighten
the needle clamp screw (_ firmly by turning it clockwise_
[] To see if the needle is good, place the flat side of the
needle onto something flat (eg needle plate or glass)_,
The gap between the needle and the flat surface should
be consistent,. Never use a bent or blunt needle°
A damaged needle can cause permanent snags or runs
in knits, fine silks and silk-like fabrics°
To Remove and Attach the Foot Holder
O Thumb screw
(_ Foot holder
(_ Presser bar
o To remove
Remove the thumb screw (_ by turning it counterclock-
wise with a screwdriver,
° To attach
Match the hole in the foot holder (_ with the threaded
hole in the presser bar (_. Fit the thumb screw C) into
the hole Tighten the screw (_ by turning it clockwise with
screwdriver..
f
%
J
[]
Flat side
Lado piano Needle
M_plat _ Aguja
Aigutlle
[] //
I
I
I° 1
........ J
10