Filter
Top Products
Cleaning the Shuttle Race
This area must be kept free of dust, lint and occasional
tangled thread Clean the shuttle race area about every three
months
• Cleaning the shuttle area
(3"_Bobbin case
(_) Levers
_) Shuttle race cover
(_ Shuttle
_3) Shuttle race
(_) Center pin on the shuttle
0 Shuttle driver
® Pointed hook
(_) (Oil here)
1, Raise the needle bar to its highest point and remove the
bobbin case (_,,
2. Push shuttle race levers (_) aside. Lift shuttle race
cover (_ and take shuttle Qout
3, Clean the shuttle race 0 with a lint brush°
4. Put a drop of oil on the center pin of the shuttle (_) and
shuttle race(3)_ Do not over oil.
. Replacing shuttle assembly
(_) Levers
(_ Shuttle racecover
Q Shuttle
(_) Shuttle race
(_) Center pin on the shuttle
0 Shuttle driver
® Pointed hook
_b (Oil here)
1.,Position shuttle race (_)as illustrated so that the shuttle
driver 0 is forming haft moon on the left side of the
machine_
2 Hold shuttle (_) by center pin (_ and position shuttle so as
to form a haft moon on the right side. The pointed hook (_)
will be on the bottom,,
3. Place shuttle race cover (_) into place over shuttle
assembly.
4, Snap the levers (_) back into the original position.
I I
0
J
64