Kenmore 1T6.31100 Vacuum Cleaner User Manual


 
MOTOR SAFETY FILTER CLEANING ]
WARNING
Electrical Shock Hazard
Unplug power cord from electrical outlet.
Do not operate the vacuum cleaner
without the motor safely filter. Be sure the
filter is dry and properly installed to
prevent meter failure and/or electrical
shock.
MOTOR SAFETY FILTER
Check motor
safety filter
frequently and
clean when dfrtyo
Remove the dust
bag as outlined in
the DUST BAG
REPLACEMENT
section,
Motor Safety
Filtel
If the filter, located in the bottom of the
dust bag chamber, is dirty, remove it by
pulling forward out from under the ribs.
Wash the foam filter in warm soapy
water, rinse and dry thoroughly by
squeezing the filter in your hand and
letting it air dry.
DO NOT wash in the dlshwasher_
DO NOT install damp.
Replace the foam filter by sliding it back
into place under the ribs in the dust bag
chamber.
Replace the dust bag as outlined in the
DUST BAG REPLACEMENT section.
I EXHAUST FILTER REPLACEMENT I
The HEPA exhaust filter must be replaced 3. Place new filter cartridge into cover
when dirty. It should be replaced
regularly depending on useconditions.
The filter CANNOT be washed as it will
lose its dust trapping abilily_
Note: See PARTSAND FEATURES
for the exhaust filter number.
1. Remove
exhaust filter
cover by
pressing the
release tab on
the cover and
rotating out
from vacuum
cleaner.
2. Remove the
filter cartridge
from cover.
making sure that airflow arrow on side of
cartridge points into cover_
Place foam seal of filter against the
vacuum cleaner body_
Exhaust
Filter
"_--Exhaust
Filter
4. Replace the exhaust filter cover by
placing bottom tabs in slots and raising
cover up until it snaps into place
18