Filter
Top Products
Troubleshooting Guide (cont'd)
Leakage Checkpoints
Use this guide to check a "Leaking" water heater. Many suspect-
ed _Leakers" arenot leaking tanks. Often the source of the water
can be found and corrected.
If you are not thoroughly Familiar with your local gas codes your
water heater, and safety practices, contact the
Center to check the water heater.
CAUTION
Read this manual first. Then before checking the water I
heater make sure the gas supply has been turned
"OFF", and never turn the gas "ON" before the tank is
comp etely fullof water.
®
0
0
A CAUTION
Never usethis water beater unlessit iscompletely filled
with waten "I"6prevent damage to the tank, the tank_
must be filled with water. Water must flow from the hot
water faucet before turning "ON" gas to the water_
heater. I
O Water at the draft hood is water which has
vapor
condensed out of the combustion products. This is caused
by a problem in the vent. Contact the Sears Service Center
O *Condensation may be seen on pipes in humid weather or
pipe connections may be leaking.
O'The primary anode rod fitting may be leaking.
Small amounts of water from temperature-pressure relief
valve may be due to thermal expansion or high water
pressure in your area.
*The temperature-pressure relief valve may be leaking at
the tank fitting.
Water from a drain valve may be due to the valve opened
slightly.
O'The drain valve may be leaking at the rank fitting.
O Combustion products contain water vapor which can
condense on the cooler surfaces of the tank. Droplets
form and drip into the fire or run on the floor. This is
common at the time of startup after installation and when
incoming water is cold.
O
Water in the water heater b0kom or on the floor may be
from condensation, loose connections, or the relief valve.
DO NOT replace the water heater until a flail inspection
of all possible water sources is made and necessary
corrective steps taken. Leakage from other appliances,
water lines, or ground seepage should also be checked,
NOTE: To check where threaded portion enters ta_k,
insert cotton swab between jacket opening and fitting.
If cotton is wet, follow "Draining" instructions in the
"Service and Adjustment" section and then remove
fitting. Put pipe dope or teflon tape on the threads
and replace. Then follow "Filling the Water Heater"
instructions in the "Installation Instructions" section.
26