Filter
Top Products
Operating Instructions (cont'd)
Temperature Regulation
Due to the nature of the typical gas water heater, the water tem-
erature in certain situations may vary up to 30°F higher or
ro_werat the
point of use such as, bathtubs, showers, sink, etc.
This means that when the temperature adjustment dial is set at
the mark approximating 120°F, the actual water temperature at
any hot water tap could be as high as 150°F or as low as 90°E
Turn the water temperature dial clockwise (_"_) to decrease
the temperature, or counterclockwise (_'_) to increase the
temperature.
Any water heater's intended purpose is to heat water. Hot water
is needed for cleaning (bodies, dishes, clothing). Hot water will
present a scald hazard. Depending on the time element, and the
people involved (normal adults, children, toddlers, elderly,
infirm, etc.) scalding may occur at different temperatures.
AWARNING
HOTTERWATERCAN SCALD:Water heatersare intendedto
producehot water.Water heatedto a temperaturewhichwill
satisfyclotheswashing,dishwashing,andothersanitizingneeds
canscaldand permanentlyinjureyouuponcontact.Some peo-
pleare more likelyto be permanentlyinjuredbyhotwaterthan
others.Theseincludetheelderly,children,theinfirm,orphysical.
ly/mentallyhandicapped.If anyoneusinghotwater inyourhome
fitsintooneofthesegroupsor ifthereisa localcodeor statelaw
requiring acertaintemperaturewateratthehotwater tap,then
youmusttakespecialprecautions.Inadditionto usingthelowest
possibletemperaturesettingthat satisfiesyourhotwaterneeds,
a meanssuchasa mixingvalve,shouldbeusedat the hotwater
tapsusedbythesepeopleor at thewater heater.Mixingvalves
areavailableat plumbingsupplyorhardwarestores.Followman-
ufacturersinstructionsfor installationof the valves.Before
changingthe factory setting on the thermostat, read the
'q'emperatureRegulation"sectionin this manual.
AWARNING ]
Never allow small children to use a hot water tap, or to draw I
their own bath water. Never leave a child or handicapped per- I
sonunattended ina bathtub or shower. ]
The thermostat of this water heater has been factory set at its
lowest position, to reduce the risk of scald injury. It is adjustable
and must be reset to the desired temperature setting. The mark
(at) indicative of approximately 120°F is the preferred starting
point. Some states have a requirement for a lower setting. If you
need hotter water, follow directions for temperature adjustment,
but beware of the warnings in this section.
PILOT LIGHTING Set here before attempting to light pilot.
A-Is a thermostat setting of approximately
120°E which will supply hot water at the
most economical temperatures. The
temperature adjustment knob can be
turned lower than 120°F if desired.
A-Is a thermostat setting of approximately
130°E
B-Is a thermostat setting of approximately
140°E
C-Is a thermostat setting of approximately
150°E
VERYHOT- Is a thermostat setting of 160°F. It is
recommended that the dial be set lower
whenever possible.
NOTE: Water temperature range of 120°--140°F recom-
mended by most dishwasher manufacturers.
AWARNING ]
Shouldoverheatingoccuror the gassupplyfail to shut off,
turn "OFF" themanual gascontrolvalveto the appliance.
19