Filter
Top Products
Installation Instructions (cont'd)
Water Piping
_WARNING
HOTTERWATERCAN SCAL_.Water heatersareintendedto
i_. ucehotwoter..Water heatedto a temperaturewhichwill
satisfyclotheswashln&dishwashing,andothersanitizingneeds
canscaldandpermanentlyinjureyouuponcontact.Somepeo-
pleare moreIE_qyto bepermanentlyinjuredbyhotwaterthan
others.Theseindudetheelderigchildren,theinlirm,or physicag
ly/mentallyhandicapped.Ifanyoneusinghotwaterinyourhome
Ett intooneofthesegroupsor ifthereisa localcodeor statelaw
requiringa certaintemperaturewaterat thehotwatertap,then
youmusttakespecialprecaution_Inadditiontousingthe lowest
possibletemperature settingthatsatisfiesyourhotw_r needs,
a meanssuchasa mixingvalve,shouldbeusedat thehot water
tapsusedby these peopleor at the water he_er. Mixingvalves
areavailableat plumbingsupplyorhanfwerestere_Followman-
ufacturersinstructionsfor installationof the valves•Before
changingthe factory settingon the thermostat, read the
'_TemperatureRegulation"sectioninthis manual.
This water heater shall not be connected to any heating systems or
component(s) used with a non-potable water heating appliance.
If a water heater is installed in a closed water supply system;
such as one having a back-flow preventer, check valve, water
meter with a check valve, etc.., in the cold water supply; means
shall be provided to control thermal expansion. Contact the
local utility or local Sears Service Center on how to control this
situation.
NOTE: Toprotect against untimely corrosion of hot and
cold water fitdngs_ it is strongly recommended that all-elec-
tric unions or couplings be installed on this water heater
when connected to copper pipe.
The iUustration shows the attachment of the water _iping to the
water heater. The water heater is equipped with 3A water con-
nections.
NOTE: If using copper tubing, solder tubing to an adapter
before attaching the adapter m the cold water inlet connec-
tion. Do not solder the cold water supply line directly to the
cold water inlet• It will harm the dip tube and damage the
tanL
Look at the top cover of the water heater. The water outlet is
marked hot. Put two or three turns of teflon tape around the
threaded end of the threaded-to-sweat coupling and around
both ends of the 3A threaded nipple. Using fexible connec-
tors, connect the hot water pipe to the hot water outlet on
the water heater.
Look at the top cover of the water heater. The cold water
inlet is markedcold. Put two or three turns of teflon tape
around the threaded end of _e threaded-to-sweat coupling
and around both ends of the 3A threaded nipple. Using flexi-
ble connectors, connect the cold water pipe to the coldwater
inlet of the water heater.
NOTE." This water heater is super insulated to minimize
heat loss from the tank. Further reduction in heat loss
can be accomplished by insulating the hot water lines
from the water heater.
INSTALLATION COMPLETED USING
SEARS INSTALLATION KIT
HOT OUTLET
TO HOUSE
THREADED TO
SWEAT COUPLING
FLEXIBLE WATER
CONNECTORS
COLD INLET
WATER LINE
THREADED TO
SWEAT COUPLING
-- 3/4" THREADED
H EAT TRAP
%
--TEPIPEEATURE-
PRESSURE
RELIEF VALVE
-- DISCHARGE
PIPE (Do not
cap or plus)
--6" AIR GAP
FLOOR DRAIN
11