Filter
Top Products
BELT ROUTING
Correct Routing of Belt
(Selector In Carpet Position)
( I =-f. /°_(_,-_'J, Carpet/Bare
Brush" _ / -'_I.
I" MOlOr
Assembly Carpet/Bare Floor Shaft
Selector Shaft
Incorrect Routing of Belt
(Belt on Selector Shaft)
" " Carpet/Bare
Floor Pedal
Brush Motor
Assembly Carpet/Bare Floor Shaft
Selector Shaft
Incorrect Routing of Belt
(Selector In Bare Floor Position)
/ _, Carpet[Bare
i 't? Fl°°rPedal
Assembly Belt Carpet/Bare Floor
Selector Shaft
Press firmly, checking to see that each
end is completely inserted.
Belt
A
Assembly
Check to see that the belt is centered in
the belt groove. Turn the brush assembly
with your fingers to see that it turns freely.
To re..attach the base plato, insert the
tabs into the slots along the front edge of
the base. Place the vacuum in full upright
position. Lower the base plate to its origi-
nal position.
Furl Upright Position
Tab Locations
As the base ls lowered the inner areas
will brush against the dust compartment
wheels. A gentle pull outward may assist
in reassembly.
Two Locking Tabs Press the
base plate
down until
the two
locking tabs
snap into
place.
Slide the right
latch to the
right and the
left latch to
the left to
secure.
Return the cleaner to the upright position
before plugging into the electrical outleL
18