Filter
Top Products
Check motor safety filter frequently and
change when dirty_
Electrical Shock Hazard
Do not operate the cleaner without
the motor safety filter. Be sure the
filter is dry and properly installed
to prevent motor failure and/or
electrical shock.
Always unplug power cord from
electrical outlet before performing
any service on vacuum.
J Ii'll JIlljl IIIIHI
TO REMOVE BAG:
Press the release Release
button located on Button
the top of the bag
cover.
Grasp the dust
bag collar and
pull gently, care-
fully removing
the dust bag.
Pull the bag
cover forward.
Remove and lay
aside.
MOTOR SAFETY FILTER
ELECTROSTATIC
This white and grey filter must be
replaced when dirty. It should be replaced
regularly depending on use conditions.
The filter cannot be washed as it will
lose Its dust trapping ability,
NOTE: See PARTS AND FEATURES for
motor safety filter #.
If the motor safety filter located at the
base of the bag cavity is dirty, remove it
by pulling forward out from under the ribso
Replace the filter,white side up, by slld-
ing it back into place under the ribs in the
bag cavity.
TO REPLACE BAG:
Dust Bag
Seal Tab
Fold the
safety sea!
tab on the
new bag
away from the
opening that
fits on the dirt
tube.
CAUTION
NEVER REUSE A DUST BAG.Vary
fine materials, such as carpet
freshenars, face powder, fine dust,
plaster, soot, etc. can clog the bag
and cause it to burst before it is
full. Change bag more often when
vacuuming these materials.
iiiii,11111
14