Filter
Top Products
_, WARNING
Electrical Shock Hazard
Unplug power cord from electrical outlet,
Do not operale the vacuum cleaner
without the motor safely filler. Be sure the
filter is dry and properly installed to
prevent motor failure and/or electrical
shock,
iiiii iiiiiii i
MOTOR SAFETY FILTER
Check motor safety
filter frequently
and clean when
dirty°
MOTOR SAFETY FILTER CLEANING
Filler Cover
Molar Safety
Filler
l
Remove the dust bag as outlined in the DUST
BAG REPLACEMENT section,
If the filter_ located in the bottom of the dust
bag chamber_ is dlrty_ remove it by pul]lng
forward out from under the ribs,
Wash the foam filter in warm soapy water,
rinse and dry thoroughly by squeezing the
filter inyour hand and letting it air dryf
DO NOT wash in the dishwasher.
DO NOT install damp,
Replace the foam filter by sliding it back into
place under the ribs in the dust bag
chamber,
Replace the dust bag as outlined in the DUST
BAG REPLACEMENT section,
EXHAUST FILTER REPLACEMENT
The HEPA exhaust filter must be replaced
when dirty. It should be replaced
regularly depending on use conditions_
The filter CANNOT be washed as it will
lose its dust trapping ability.
Note: See PARTS AND FEATURES
for the exhaust filter number.
1o Remove
exhaust filter
cover by
pressing the
release tab on
the cover and
rotating out
from vacuum
cleaner_
2, Remove the
filter cartridge
from cover.
3. Place new filter cartridge into cover
making sure that airflow arrow on side of
cartridge points into cover_
Place foam seal of filter against the
vacuum cleaner body°
Exhaust
Filter
Seal Against
Vacuum Cleaner
4. Replace the exhaust filter cover by
placing bottom tabs in slots and rotating
in until cover snaps into place,
]
1B