Filter
Top Products
CANISTER
1. Open the canister hood
2. Check to see that the dust bag is properly
installed See BAG CHANGING for
instructions.
3. Check to see that the motor safety filter is
properly instalied See MOTOR SAFETY
FILTER CHANGING for instructions.
HOOD AND TOOL
STORAG E COVER
It is normal for the canister hood and tool
storage cover to come off when opened
further than needed. Line up the hinge slots,
insert the hinges into the slots, and close the
hood and tool storage cover to reinstall
CAUTION
Never open canister hood with the tool
storage cover open. This will help to
prevent damage from occurring to the
canister hood andlor tool storage cover.
HOSE
1. Line up tl_e hose
latch tab and notch
in canister hood
and insert hose
into canister until it
snaps into place
To remove: Do not open hood before
removing hose. With hood closed, lift hose
latch tab upward and pull on hose.
Handle
Lock
Handle
Quick
2. Insert handle
into wand until
lock button
snaps in place.
Be sure hose is
not twisted°
To remove:
Press handle
quick release
button and pull
up on handle.
To store; Disconnect hose form wands and
canister to prevent stress on hose during
storage_ Store hose in a loosely coiled
position on the hose covering is not stressed°
This canister is equipped with an on-board
storage area for a Pet PowerMate
attachment.
To Install:
Open the Pet PowerMate storage cover
Insert the Pet PowerMate, press down into
place, and close the lid securely.
To Remove:
Open the storage cover. Remove Pet
PowerMate from the storage area and use
as needed (see ATTACHMENTS and
ATTACHMENT USE TABLE),
f et PowerMate
Storage Cover