Filter
Top Products
Exhaust
Filter.
5. To replace the
exhaust filter
cover place the
two tabs on the
filter cover into
the slots on the
canister,
4. Replace the
exhaust filter
_ cartridge° Place
the new filter into
the canister with
the foam seal
towards the
canister.
6. While holding
latch down
rotate filter cove r
into place.
7. Release latch and verify that filter cover
is locked into place°
AIthough the dirt sensor feature in your
Kenmore canister is designed for years of
trouble free use, the passage of dirt through
the air passage system can coat the lens
causing the green light to come on and stay on
- never switching to red. When this happens
the ;enses must be cleaned.
i i i,n, I' i,, i ,
,CAUTION
Never use water or any cleaning solution
when cleaning the lenses. The residue of
the water or cleaners will accelerate the
recoating of the lenses and make
cleaning necessary sooner.
TO CLEAN THE LENSES
1. Remove the
handle by pressing
the handle quick
release button
Lock
Quick
Release--_ '_
/
;*-- Handle
!
0
o
Approx° ...,_._..,=,
5 inches "o,_,CL°=E..__...L
: )
', , Sensor
: i Lenses
2. As indicated by the illustration, the two dirt
sensor Ienses are located on the inside of the
handle, approximately 5 inches/130 mm down
(note the arrows), These lenses should be
cleaned periodically, To reach the sensor
lenses, use a small brush such as a bottle
brush. Brush each sensor lens several times to
remove dust and dirt.
I8