Filter
Top Products
EMPTY RECOVERY TANK
Unplug carpet cleaner from electrical outlet.
Automatic "shut off"
When the recovery tank (lower tank) is full, the
automatic shut-off mechanism will shut off the carpet
cleaner suction (suction will be noticeably reduced).
The carpet cleaner will no longer pick up dirty solution
and the motor sound will become noticeably higher in
pitch.
When this happens, turn carpet cleaner off and empty
recovery tank before continuing use.
Check the solution tank also; it may need to be
refilled.
Never use unit w{thout the orange float or float
retainer, located in the recovery tank, in place. If
broken or dislodged, take to a Sears Parts and
Repair Center for repair.
_Release latches (A) located on either side of
recovery tank (B) by pushing latch toward rear of
carpet cleaner.
_Slide tank (B) straight out and carry it to a sink
or drain. Remove lid.
_Empty tank through opening (C). To remove any
debris that has collected on the lint screen (D),
flush with water.
Check to be sure that the orange float and float
retainer, located in the recovery tank, are in pmace.
If broken or dislodged, take to a Sears Parts and
Repair Center for repair.
_Reposition lid by aligning hinges (E) at rear of
tank. Press down on front of lid to secure in
place. Replace tank.
Push latches (one on each side of tank) toward front
of carpet cleaner to lock tank in place. Be sure both
sides are properly latched.
ON/OFF PEDAL and
HANDLE RELEASE PEDAL
_Step on pedal (A) to turn carpet cleaner on.
Step on pedal again to turn carpet cleaner off.
Step on pedal (B) to lower handle to operating
position. Handle does not Jock into a singJe position
but "floats" to alJow convenient operation.
14