Filter
Top Products
9
English
■
4. Press the UP, DOWN, >, or < button to
select the preset number.
UP button: Increases the preset number by 1.
DOWN button: Decreases the preset number by 1.
> button: Increases the preset number by ten.
< button: Decreases the preset number by ten.
■
5. Press the SET button.
After 1 second, the display returns to the broadcast frequency
display.
■
6. Repeat above steps 1 to 5 for each station
you want to store in memory with a preset
number.
To cancel during presetting,
press the CANCEL button in
step 3 or 4.
To change the preset stations,
repeat the same steps as
above.
In each band, you can automatically preset FM-30, AM (MW/LW)-
15 stations. Preset numbers will be allocated as stations are found,
starting from the lowest frequency and moving up the frequency.
■
1. Select a band by pressing the TUNER
BAND button.
■
2. Press the AUTO PRESET button on the
Remote Control for more than two sec-
onds.
■
3. Repeat steps 1-2 for the other band.
■
If you want to change the preset stations, carry out the Manual
Presetting for the desired preset numbers.
CAUTION: If the System is unplugged or if a pow-
er failure occurs, the preset stations will be
erased after about 24 hours. If this happens, you
will need to preset the stations again.
When you are tuned into an FM stereo broadcast, the “ST (Stereo)”
indicator lights up and you can hear stereo effects.
If an FM stereo broadcast is hard to receive or noisy, you can select
Monaural mode. Reception improves, but you lose any stereo ef-
fect.
Press the FM MODE button on the Remote Control so that
the “MONO” indicator lights up on the display.
To restore the stereo effect,
press the FM MODE button on the
Remote Control so that the “MONO” indicator goes off.
Auto Presetting
To Change the FM
Reception Mode
AUTO
PRESET
TUNER
BAND
(for 2 seconds)
FM MODE
ST(Stereo) MONO
Ux5000-e.fm Page 9 Wednesday, April 8, 1998 10:51 AM