Filter
Top Products
7
English
Turn the VOLUME control of the Unit clockwise to increase the
volume or counterclockwise to decrease it.
OR
With the System turned on, press the VOLUME + button on the Re-
mote Control to increase the volume or press the VOLUME – button
to decrease it.
CAUTION: DO NOT turn on the System and/or
start playing any source without first setting the
VOLUME control to minimum, as a sudden blast of
sound could damage your hearing, speakers and/
or headphones.
For private listening
Connect a pair of headphones to the PHONES jack. No sound
comes out of the speakers.
Be sure to turn down the volume before connecting or putting on
headphones.
You can reinforce the bass sound to maintain rich, full bass at low
volume (you can use this effect only for playback):
To get the effect,
press the AHB (Active Hyper Bass) SUPER
PRO button on the Unit or the Remote Control.
The “BASS” indicator lights up on the display.
To cancel the effect,
press the button again.
The “BASS” indicator goes out.
You can control the tone by changing the bass and treble.
BASS Control ———————————
You can adjust the bass level (low frequency range level) between
–6 and 6. (0: Flat)
■
1. Press the BASS button on the Remote Con-
trol.
■
2. Press the UP or DOWN button on the
Remote Control to adjust the bass level.
TREBLE Control ——————————
You can adjust the treble level (high frequency range level) between
–6 and 6. (0: Flat)
■
1. Press the TREBLE button on the Remote
Control.
■
2. Press the UP or DOWN button on the
Remote Control to adjust the treble level.
In addition to a standard digital clock, an analogue clock (which ad-
vances every five minutes) can be displayed. The clock display or-
der varies according to the System mode:
In Standby mode ——————————
Every time you press the DISPLAY button on the Remote Control
(or the CLOCK button on the Unit), the clock display changes as
shown below.
Digital Clock + Analogue Clock
= Analogue Clock = Digital
Clock
= (back to the beginning)
When the System is turned on ———
Every time you press the DISPLAY button on the Remote Control
(or the CLOCK button on the Unit), the time display changes as fol-
lows:
Current Source + Analogue Clock
= Analogue Clock = Digital
Clock
= Current Source = (back to the beginning)
Note:
The clock must be set to the correct time first. (See “Setting
the Clock” on page 13.)
Adjusting the Volume
Reinforcing the Bass Sound
(AHB SUPER PRO)
Tone Control (BASS/TREBLE)
DOWN
UP
BASS
DOWN
UP
TREBLE
Showing the Time (DISPLAY)
Ux5000-e.fm Page 7 Wednesday, April 8, 1998 10:51 AM