Filter
Top Products
4
USA/Canada
Safety Notices
• Burn solid wood fuel only
• Do not use chemicals or fluids to start the fire.
Do not burn garbage or flammable fluids.
• If this room heater is not properly installed, a
house fire may result. To reduce the risk of fire,
follow the installation instructions. Failure to
follow these instructions may result in
property damage, bodily injury, or loss of life.
• Contact the local building or fire officials about
restrictions and installation inspection
requirements in your area.
• Do not connect this stove to any air
distribution duct or system.
• Extremely hot while in operation! Keep
children, clothing and furniture away. Contact
will cause skin burns.
• Install smoke detectors in the living areas and
bedrooms of your home. Test them regularly and
install new batteries twice annually.
When installed in the same room as the stove, a
smoke detector should be located as far from the
stove as possible to prevent it from sounding
when adding fuel to the fire.
• Avoid creating a low pressure condition in the
room where the stove is operating. Be aware
that operation of an exhaust fan or clothes
dryer can create a low pressure area and
consequently promote flow reversal through
the stove and chimney system. The chimney
and building, however, always work together
as a system - provision of outside air, directly or
indirectly to an atmospherically vented
appliance will not guarantee proper chimney
performance. Consult your local Jøtul
authorized dealer regarding specific
installation/performance issues.
• Jøtul recommends that this stove be installed
by a professional solid fuel technician or that
you consult one if you do the work yourself. Also,
consult your insurance company regarding any
other specific requirements.
Installation
If this solid fuel room heater is not properly installed, a
house fire may result. For your safety, follow the
installation directions. Contact the local building or fire
officials about restrictions and installation inspection
requirements in your area.
Your local officials have final authority in determining if a
proposed installation is acceptable. Any requirement by
the local authority having jurisdiction that is not
specifically addressed in this manual, defaults to NFPA
211, and local codes in the U.S. or in Canada, CAN/CSA-
B365-M and local codes.
Assembly Before Installation
Unpack the Stove
Inspect the stove for damage. Contact your dealer
immediately if any damage is found. Do not install the
stove if any damage is evident.
Contents:
• Ash Lip
• Door Handle
• Hardware Bag
- Flue Collar gasket
- 6” Pipe Adaptor
Flue Collar Installation
The Flue Collar is oriented in the Top Exit position. Apply
the gasket to the collar before installing the chimney
connector.
Position Reversal
Follow this procedure to change the collar to a Rear Exit
position if appropriate.
1. Remove the Flue Collar by reaching through the
opening and removing the two bolts that secure it to
the top plate.
2. Using tin snips, cut out the panel from the Rear Heat
Shield for the Flue Collar to pass through. See fig. 1.
3. Remove the two screws that attach the Coverplate to
the rear outlet. Hold onto the Coverplate while
removing the second screw so that it does not fall
out. See fig. 2.
4. Using the same screws, attach the Flue Collar to the
rear outlet and the Coverplate to the Top Plate.
5. Install the Flue Collar gasket. Remove the protective
paper from the adhesive side and apply the gasket to
the inside of the Flue Collar.