Filter
Top Products
7
Assemble Filter System
1. Open the 2 latches on top of the blower transition.
2. Open the filter access door.
3. Remove the filter from the housing assembly. The filter will be
reinstalled at the end of the installation process.
4. For 30" (76.2 cm) base cabinet installation only:
a.) Preinstall 2 - #8 AB x ½" black screws provided with kit
into the predrilled holes in the cabinet floor next to the left
side cabinet wall.
Top View of Cabinet
b.) Leave approximately an ¹⁄₈" (3.2 mm) gap between the
bottom of the screw head and the cabinet floor.
c.) Place the housing assembly into the cutout in the cabinet
floor aligning the slotted flange on the left side under the
screw heads (A).
d.) Install 2 - #8 AB x ½" screws (B) through the round holes
in the right side of the housing and into the predrilled
holes in the cabinet floor and tighten.
Top View of Cabinet
e.) Tighten the 2 - #8 AB x ½" screws on the left side (A).
For 36" (91.4 cm) base cabinet installation only:
a.) Place the housing assembly into the cutout in the cabinet
floor aligning the slotted flange with predrilled holes in
cabinet floor.
Top View of Cabinet
b.) Install 4 - #8 AB x ½" screws (A) through the round holes
in the housing and into the predrilled holes in the cabinet
floor and tighten.
5. Attach one end of the flex duct to the blower exhaust scroll
with 1 clamp.
Front View of Cabinet
A.Left side cabinet wall
B.Predrilled holes in floor
C.Toe-kick area
A
B
C
¹⁄₈"
(3.2 mm)
A.Left side preinstalled screws
B.Right side screws
A. 4 - #8 AB x ½" screws
A. Blower exhaust scroll
B.Clamp
C.Flex duct
A
B
A
A
A
B
C