Filter
Top Products
5
For a 36" (91.4 cm) base cabinet: The poster board template
will be located closer to the center of the cabinet. Note the area
to be cut out of the cabinet floor is in the toe-kick area.
Top View of Cabinet
NOTE: For illustration purposes, the cabinet front is not shown in
most of the following illustrations.
IMPORTANT: Do not cut the cabinet front.
Cutout Steps
1. Use the framing square and draw a line on the cabinet floor
parallel to the edge of the blower exhaust scroll.
Top View of Cabinet
2. Flip the framing square over and slide it against the cabinet
front.
3. Extend the line made in Step 1 to the cabinet front.
NOTE: For clarity, the cabinet front is not shown in this view.
4. Locate template included with the installation kit.
5. Center the line made in Step 3 within the alignment notch of
the template. Make sure the edge of the template is against
the cabinet front.
6. Tape template to bottom of cabinet with masking tape as
shown in the following illustrations.
30" (76.2 cm) Base Cabinet Template Position
Top View of Cabinet
A. Front of cabinet
B.Area to be cut out
C.Toe kick
D.Template
E. Left side of cabinet
A.Blower exhaust scroll
B. Framing square
C.Cabinet floor
A
B
C
D
E
A
B
C
A.Pilot hole locations
B.Alignment notch
A. Left side of cabinet
B.Toe-kick area
C. Area to be cut out
D.Cabinet front
E.Center mullion
A
B
A
B
C
D
E