Filter
Top Products
4
To rotate blower motor (blower style A only):
NOTE: The “Top” label location on the blower motor is at the
9 o’clock position.
1. Using a ratchet with a ³⁄₈" socket and supporting the motor
with one hand, remove the 4 machine nuts that attach the
blower motor to the exhaust scroll.
2. Remove the blower motor and wheel assembly from the weld
studs.
3. When the motor mounting plate clears the threaded weld
studs, rotate the assembly clockwise 90° and reinstall the
4 #10-32 machine nuts.
4. Verify the “Top” label is positioned as shown.
Prepare the Base Cabinet Bottom
Installation of the Jenn-Air
®
Duct Free Filter System requires
modification to the cabinet base bottom in the toe-kick area of
the base cabinet. A cutout and 4 pilot holes are required for
mounting the Duct Free filter housing.
Remove Cabinet Brace
1. Open the cabinet doors.
2. Determine if a wooden or plastic brace is attached to the
cabinet floor and to the back of the center mullion as shown
in the following illustration.
3. If a wooden or plastic brace is installed, remove the brace.
Cabinet Floor Cutout
The installation of the Jenn-Air
®
Duct Free Filter System
Accessory Kit is dependent upon the type of cooktop purchased
and the base cabinet dimension. For example, a 30" (76.2 cm)
cooktop is designed to fit in a 30" (76.2 cm) base cabinet, and a
36" (91.4 cm) cooktop is designed to fit in a 36" (91.4 cm) base
cabinet.
The poster board template provided with the kit is universal.
However, the actual location of the exhaust cutout is different
between the 30" (76.2 cm) and 36" (91.4 cm) products, due to the
length difference between the base cabinets. The sketches that
follow show the general position of the template.
For a 30" (76.2 cm) base cabinet: The template will be located
in the front left corner. Note the area to be cut out of the cabinet
floor is in the toe-kick area.
Top View of Cabinet
A. Top label
B. Blower motor
C.Motor mounting plate
D.Weld stud location
E.Blower wheel
A.Top label
B
A
D
C
E
A
A. Brace
B.2½" (6.4 cm)
C. 3" (7.6 cm)
D.Floor
A. Front of cabinet
B.Area to be cut out
C.Toe kick
D.Template
E.Left side of cabinet
D
B
C
A
A
B
C
D
E