Filter
Top Products
8
Inserting the bobbin
z Place the bobbin in the bobbin holder with the
thread running off in a counterclockwise direction.
q Thread
w Bobbin holder
* Refer to the threading chart shown on
the hook cover plate.
q
w
r
r
t
4
3
2
1
e
x Guide the thread into the notch on the front of
the bobbin holder.
Draw the thread to the left, sliding it between the
tension spring blades.
e Front notch
c Continue to draw the thread lightly until the
thread slips into the side notch.
Pull out about 10 cm (4˝) of thread to the rear.
r Side notch
v Reattach the hook cover plate.
t Hook cover plate