Invacare 1900S Manual

A SERVICE OF

next previous

SECTION 2—OPERATING THE BATH LIFT

Part No. 1148113 13 1900/1900S Bath Lift

6. Aftertenminutes,rinsetheseatsurface,safetystrap,shoulderstrap,armrests,and

anyothernon‐electronicsurfacewiththeshowerwandofthebath.Refertothe

individualbathingunit’sowner’smanualforusingtheshowerwand.

CAUTION

DO NOT spray the push handles, scale, or hand pendant with water. Sprayed water

may damage the electronic components of the lift.

7. Lightlywipethepushhandles,scale,andhandpendantwithadampcloth.

8. Dryallsurfaceswithacleantowel.

9. Removethebathliftfromthetub.ReverseSTEPS13to16inTransferringinto/outof

theBathingUnitonpage 9.

FIGURE 2.7 Disinfecting the Lift

Mounting the Battery Charger

NOTE:Forthisprocedure,refertoFIGURE 2.8.

NOTE:Refertoyourlocalregulationsconcerningpropermountingprocedures.

1. Placethebatterychargerwithmountingbracketonthewallatthedesiredposition.

2. Withapencil,markthemiddleholeposition.

3. Measuredown6½inchesfromthepencilmarkanddrillonemountinghole.

4. Installthebottommountingscrewuntilthereisanapproximate1/8‐inchgapbetween

thescrewheadandthewall.

5. Installthebatterychargerwithmountingbracketontothebottommountingscrew.

6. Drilltheremainingtwomountingholes.

7. Installthetworemainingmountingscrewsthroughthemountingbracketandintothe

wall.Tighten

securely.

8. Plugthebatterychargerintothewallelectricaloutlet.

NOTE:TheOnLEDshouldilluminate.

DETAIL “A” - NON ELECTRONIC SURFACES

Seat

Surface

Safety Strap

Arm Rests

Base

DETAIL “B” - ELECTRONIC SURFACES

Push

Handles

Hand

Pendant

NOTE:Shoulder

Strapnotshown.

Scale