Filter
Top Products
9
41277-01 05/98
®
Follow sub-step 1 below for all fans.
Then, use the additional instructions
for the type of mounting you have
selected: flush, standard, or angle.
ALL FANS
1. Position the fan housing over the
motor hanger adapter. Make sure
the tabs in the motor hanger
adapter fit into the notches in the
housing and that the pipe set-
screw (for standard and angle
mounting) passes through the slot
in the housing as shown in Fig-
ure 3a.
Flush Mounting
(For Low Ceilings)
1. Fit the canopy over the motor
hanger adapter as shown in Fig-
ure 3b. Make sure the canopy fits
snugly against fan assembly with
no space between the pieces.
STEP 3 - ASSEMBLING THE FAN
2. Place the large assembly washer
included with the fan over the
adapter and canopy as shown in
Figure 3b.
3. Position the slots in the assembly
washer over the threaded holes
in the adapter as shown in Figure
3c.
Figure 3b - Placing Canopy and
Washer Over Adapter
Figure 3c - Positioning Assembly
Washer Slots Over Threaded Holes
Figure 3a - Motor Hanger Adapter
Tabs and Housing Notches
Assembly
Washer
Canopy
Adapter
Top of Fan
Adapter
Threaded
Hole
Assembly
Washer