Filter
Top Products
17
41277-01 05/98
®
STEP 7 - ATTACHING LIGHT FIXTURES
Figure 7a - Removing Plug Button
and Switch Housing Cover
Switch
Housing
Cover
Plug Button
Your Whisperwind 2000™ fan may
include a light fixture. You may en-
joy the fan with or without the light
fixture. Information for wiring and in-
stalling all included Hunter light fix-
tures follows.
Note: If you purchased a
Whisperwind 2000™ without a light
fixture, you may purchase an acces-
sory light kit separately. For best per-
formance and beauty, use only
Hunter-brand light kits, Type A-Z.
Hunter light kits are designed, tested,
and UL approved for all Hunter fans,
and are available at most Hunter
dealers. To install the light kit, follow
the instructions included with the kit.
If you are not installing a light fix-
ture, turn to “OPERATING YOUR
HUNTER FAN” for additional instruc-
tions.
Switch
Housing
Cap
continued
WARNINGS
• To avoid possible electrical
shock, before installing
light fixtures, disconnect
power by turning off the
circuit breakers both to the
outlet box and to its asso-
ciated wall switch location.
If you cannot lock the cir-
cuit breakers in the off po-
sition, securely fasten a
prominent warning device,
such as a tag, to the service
panel.
• Connect house wiring to
the fan before attaching
the light kit to the fan.
• All wiring must be in accor-
dance with national and
local electrical codes and
ANSI/NFPA 70-1993. If you
are unfamiliar with wiring,
you should use a qualified
electrician.