10
42798-01 • 09/16/09 • Hunter Fan Company
10
Dip Switches
Set to 01110
Dip Switches
Set to 01001
Dip Switches
Set to 01110
Dip Switches
Set to 01001
Receiver 1
Receiver 2
Transmitter 2Transmitter 1
DIP Switches
Set to 0111
DIP Switches
Set to 0100
DIP Switches
Set to 0100
DIP Switches
Set to 0111
4 • Setting the Remote Transmitter and Receiver(cont.)
87
199
87
Install the included 12-Volt, type GP23A battery (199) into the transmitter
(87). Clean the battery contacts and also those of the device prior to
battery installation. Ensure the battery is installed correctly with regard
to polarity (+ and -). Please contact your local battery recycling center for
proper battery disposal information.
ere is a toggle switch beside the DIP switches on the transmitter (87).
Move the toggle switch toward the side that reads “CFL” if you are going to
operate the fan with the included CFL bulbs. Move the switch to the “INC”
side if you are going to use incandescent bulbs.
Change the position of the DIP switches in the remote transmitter (87) and
the receiver (86). Make sure that the DIP switches match in the remote
receiver (86) and transmitter (87). If they don’t match, the transmitter will
not function.
e remote control device complies with part 15 of the FCC rules. Changes or
modications not expressly approved by Hunter Fan Company could void your
authority to operate this equipment. Operation is subject to the following two
conditions: 1. is device may not cause harmful interference. 2. is device
must accept any interference received, including interference that may cause
undesired operation.
WARNING:
Use only the
Hunter Fan
speed control
supplied with
this fan.
Note: Remove the
battery from the
remote control
transmitter if
the product is to
remain unused
for an extended
period of time.
To remove the
battery, remove
the back cover of
the remote control
transmitter.
Remove used
batteries
promptly.
Toggle Switch
4.3
4.2
4.4
