Hunter Fan 42747-01 Manual

next previous

42747-01•09/21/07•HunterFanCompany

3 • Assembling and Hanging the Fan

You can assemble your fan for standard mounting (steps 3-1 – 3-2)

or for low proﬁle mounting (steps 3-3 – 3-4). Note: For low proﬁle

mounting, the downrod is replaced with the low proﬁle washer.

3-1. To assemble fan to hang down from a ﬂat or angled ceiling, insert

the downrod through the canopy and canopy trim ring. Feed the

wires from the fan through the downrod.

3-2. Loosen the allen head set screw on the adapter using the large

allen wrench. Screw the pipe and ball assembly into the fan

assembly. Note: When the pipe and ball assembly is fully installed,

2-3threadsonthepipewillstillbevisible;thisisnormal.Securely

retighten the set screw with a wrench or pliers. Skip to Step 3-5.

CAUTION: e adapter has a special coating on the threads. Do

notremovethiscoating;thecoatingpreventsthedownrodfrom

unscrewing. Once assembled, do not remove the downrod.

3-3. Place the low proﬁle washer (lip up) into the canopy. Be sure the

green ground wire is pointing up toward the ceiling.

3-4.Aligntheholesinthewasherwiththeholesintheadapter.

Assemblesecurelywiththree#8-32x3/4”screws.

3-5.Raisethefanandplacethehookontheceilingplatethroughthe

U-shapedholeintherim.

WARNING: Fan may fall if not assembled as directed in these

installation instructions.

Steps 3-3 – 3-4

#8-32x3/4”Screw

Low Proﬁle Washer

Steps 3-1 – 3-2

Downrod

Canopy

TrimRing

Set Screw

Step 3-5

U-shaped

Hole