Hunter Fan 42747-01 Manual

next previous

42747-01•09/21/07•HunterFanCompany

2 • Installing the Ceiling Plate

2-1. Drill two pilot holes into the wood support structure through the

outermostholesintheoutletbox.epilotholesshouldbe9/64”

in diameter.

2-2. Your fan comes with four neoprene noise isolators (“Isolators”).

Position the isolators between the ceiling plate and ceiling by

inserting the raised areas on each isolator into the holes in the

ceiling plate.

2-3. read the lead wires from the outlet box down through the hole

in the middle of the ceiling plate.

2-4. Aligntheslottedholesintheceilingplatewiththepilotholesyou

drilled in the wood support structure. For proper alignment use

slotted holes directly across from each other.

Note: e isolators should be ﬂush against the ceiling.

2-5. Place a ﬂat washer on each of the two 3” screws and pass the

screws through the slotted holes in the ceiling plate into the pilot

holes you drilled.

  Tightenthescrewsintothe9/64”pilotholes;donotuselubricants

on the screws. Do not over tighten.

Step 2-2

Flat Washer

3” Screw

Steps 2-3 – 2-5

For Angled Ceilings: Be sure to

orient the ceiling plate so that the

arrows printed on the ceiling plate are

pointing toward the ceiling peak.

Ceiling

Plate

Isolator