Hunter Fan 42700 Manual

Open as PDF

next previous

42700-01•01/15/08•HunterFanCompany

6 • Setting the Remote Transmitter and Receiver

CAUTION:eremotecontroldevicecomplieswithpart15oftheFCCrules.

ChangesormodicationsnotexpresslyapprovedbyHunterFanCompanycouldvoid

your authority to operate this equipment.

Operationissubjecttothefollowingtwoconditions:

1.isdevicemaynotcauseharmfulinterference.

2.isdevicemustacceptanyinterferencereceived,includinginterferencethatmay

cause undesired operation.

WARNING:UseonlytheHunterFanspeedcontrolsuppliedwiththisfan.

IMPORTANT!Beforeyouchangethejumpersettings,makesurethe

batteryisnotconnectedtothetransmitter.

6-1. Changethepositionofthejumpersintheremotetransmitter

andthereceiver.Makesurethatthejumpersmatchintheremote

receiverandtransmitter.Iftheydon’tmatch,thetransmitterwill

not function.

6-2. Installtheincluded12-voltbatteryintothetransmitter.

Setting Transmitter and Receiver Codes

Whentwoormorefansarelocatedneareachother,youmaydesire

tohavethereceiver/transmitterforeachfansettoadierentcode,

sothattheoperationofonefandoesnotaecttheoperationofthe

other fans.

ejumpersforthereceiverarelocatedontheatsurfaceof

thereceiver.ejumpersforthetransmitterareinthebattery

compartment.ejumpersareverysmall;youcanmovethemmost

easily using a small pair of pliers or tweezers.

4321

4 = off

3 = on

2 = on

1 = on

4 = off

3 = on

2 = off

1 = on

ReceiverJumpers

4321

4 = off

3 = on

2 = on

1 = on

4 = off

3 = on

2 = off

1 = on

Example Jumpers Settings

Receiver1 Receiver2

Transmitter 2Transmitter 1

4321

4 = off

3 = on

2 = on

1 = on

4 = off

3 = on

2 = off

1 = on