Hunter Fan 42700 Manual

next previous

42700-01•01/15/08•HunterFanCompany

7 • Wiring the Fan

All wiring must be in accordance with national and local electrical

codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a

qualiﬁed electrician.

Wallswitchesarenotincluded.Selectanacceptablegeneral-useswitch

in accordance with national and local electrical codes.

7-1. Disconnectthepowerbyturningothecircuitbreakerstothe

outletboxandassociatedwallswitchlocation.

7-2. Placethereceiverinsidethecanopy,makingsurethatthe

dipswitchesandtheovalshapedholesinthebottomofthe

receiverarefacingdowntowardthebottomofthecanopy.

7-3. Spreadthereceiverleadwirestoeachsideandfeedthewiresfrom

thetopofthefanthroughtheopenslotinthereceiver.

7-4. Placethereceiverinthecanopy.Makesuretheslotinthereceiver

is aligned with the hook in the ceiling plate.

7-5. Toconnectthewires,holdthebaremetalleadstogetherand

placeawireconnectoroverthem,thentwistclockwiseuntiltight.

Usingthesmallwireconnectors,connectthefantothereceiveras

follows:

•Connecttheyellowwirefromthefantotheyellowwirefrom

thereceiver.

•Connectthepinkwirefromthefantothepinkwirefromthe

receiver.

•Connectthegreywirefromthefantothegreywirefromthe

receiver.

•Connecttheredwirefromthefantotheredwirefromthe

receiver.

•Connecttheblackwirewithawhitestripefromthefantothe

blackwirewithawhitestripefromthereceiver.

•Connectthewhitewirefromthefantothewhitewire

(LIGHTOUT)fromthereceiver.

Steps 7-5 – 7-6

Large Wire

connector

Small Wire

connector