Filter
Top Products
Position round projection on end
of agitator (opposite the belt) into
the opening in the wall of the
nozzle base.
The cover attaches at the front of
the nozzle. Place the notched
edge at the front of the cover into
the groove in the nozzle base.
Slide belt side of agitator into
place, pushing the agitator slight-
ly to left, pulling it forward and
then down.
Roll agitator to make sure belt is
positioned properly.
While maintaining front connec-
tion, rotate cover over nozzle
base and pull nozzle cord through
opening in cover.
Turn nozzle over and replace
screws.
15