Filter
Top Products
To clean secondary filter
Disconnect cleaner from electri-
cal outlet.
The secondary filter protects the
motor from dirt particles. If the
filter becomes dirty, either clean
or replace it.
To remove secondary filter, open
cover of cleaner and lift filter off
of motor housing. Clean filter by
rinsing it in water. When dry,
position filter around motor hous-
ing with notched edge at the bot-
tom and to the back of the motor
housing.
The
belt
The belt in your power nozzle drives the agitator. It has been designed
specifically for use in this cleaner and is important for effective opera-
tion. There are other belts manufactured that are similar in shape and
size but are not designed for the HOOVER power nozzle. Such belts do
not operate the agitator correctly and may create stress which could
damage your power nozzle. Use only a genuine HOOVER Belt No.
38528-011 when a belt replacement is necessary.
When to replace the belt on power nozzle
The belt, located under the nozzle cover, should be checked from time to
time to be sure it is in good condition.To check remove the nozzle cover
(see following section). Replace the belt if it is stretched, cut, or broken.
13