Filter
Top Products
9
3-1
3-2
A
B
C
A
Replacing bag door
Reposition bag door by placing tabs
on bottom of door into opening (C).
Press top of door to snap securely
shut.
Removing bag door
To change filter bag, press down at
top of bag door and pull door
forward.
Remove door.
Removing and installing filter
bag
Grasp filter bag collar (A) and pull
collar from tube (B).
Note: Do not clean out old filter bag
and reuse. Discard used filter bag.
Hold new filter bag as shown. Align
opening in filter bag with (B).
Push (A) firmly onto (B).
Tuck in filter bag.
Secondary and final
filters
The secondary filter (A), located
behind the grill in the bottom of bag
compartment, protects the motor
from dirt particles.
If filter becomes dirty, pull off grill
and lift out filter.
Hand wash filter in cold water with
mild detergent, then air dry.
Reposition dry filter and grill.
Should you want to replace this fil-
ter, ask for HOOVER part No.
38765019.
Cleaning secondary filter
Disconnect cleaner from electrical
outlet.
3-3
3-4
Changing filter bag
Disconnect cleaner from electrical
outlet.
Reattaching filter door
The filter door is designed with a
“break-away” feature which allows it
to snap free if it is pushed open too
far.
To reattach, align hinges (C) of
cover with slots on sides of filter
area.
Press door back into place.
3-5
C
B
Cleaning final filter
The final filter assists in the filtration
process to return clean air to the
room.
To remove this filter when it be-
comes dirty, open the door on the
side of the cleaner.
Lift out filter (B) and hand wash it in
cold water with mild detergent.
Let filter air dry and reposition it on
the side of cleaner. Make sure the
green colored side of filter faces
outward. Close door.
Should you want to replace this
filter, ask for HOOVER part No.
40110004.
Do not operate cleaner without
either the secondary or final filter
in place.
3-6
Continued
➜