Filter
Top Products
Cleaning lightweight
flexible rugs
Stand on one end of rug and move
cleaner toward other end or edge.
Before reaching edge, push down
on handle. This will lift up the nozzle
(front of cleaner) as shown and will
prevent rug from clinging to cleaner.
Continue to lift up nozzle so that
when you have reached the edge, it
is completely off the rug. Move
cleaner back to start again, lower
nozzle, and use only forward
strokes.
7
Cleaning tools
Tools allow for cleaning surfaces
above the floor and for reaching
hard to clean areas.
The cleaner is ready for tool use
when handle is in upright position.
CAUTION: Agitator continues to
rotate while cleaner handle is in
upright position. Avoid tipping
cleaner or setting it on furniture,
fringed area rugs or carpeted
stairs during tool use.
2-9
2-11
Stair cleaning
A stair cleaning handle has been de-
signed for ease in using your cleaner on
stairs. With handle in operating position,
place fingers under edge of stair clean-
ing handle and guide cleaner with other
hand on upper handle.
As an alternative, you may use the hose
and furniture nozzle for stair cleaning.
Clean from bottom to top.
When using cleaning tools, the agita-
tor will continue to rotate.
CAUTION: To avoid personal injury or
unnecessary wear to carpet, and to
prevent the cleaner from falling,
always place it at bottom of stairs.
Edge cleaning
Special edge groomers are provided
on both sides of the nozzle to
remove dirt in carpet near base-
boards and furniture.
Guide either side of nozzle parallel
to edge of carpet or furniture.
2-10
2-12
Continued
➜
How to attach tool
cover
The tool cover is designed with a
“break-away” feature which allows it
to snap free if it is pushed open too
far.
To reattach, align hinges of cover
with slots on sides of tool storage
area.
Push cover down to secure in place.
How to clean tools
To clean the hose, wipe off dirt with
a cloth dampened in a mild deter-
gent. Rinse with a damp cloth.
Cleaning tools may be washed in
warm water with a detergent. Rinse
and air dry before using.
2-13
A
Removing hose
When using cleaning tools, cleaner
handle should be in the upright
position. Also, turn cleaner OFF
before disconnecting and con-
necting hose to hose tube (A).
To use hose, lift hose end as shown.
Lower cover (B) onto hose tube.
When you are finished cleaning with
the tools, be sure to lift cover from
hose tube and reposition hose
end into tube.
B