Filter
Top Products
Questions or Concerns?
The Hoover Company wants to quickly resolve any concerns about your
cleaner or questions regarding its use. Look on the list provided with the
product for your local
Hoover Factory Service Center
or in the Yellow
Pages under “Vacuum Cleaners
-
Household” for the nearest
Authorized
Hoover Warranty Service Dealer
(Depot) or call:
l-800-944-9200
for an automated referral of
authorized service outlet locations (U.S. only)
OR
l-330-499-9499
to speak with a representative in the
Hoover Consumer Response Center.
DO NOT RETURN THIS PRODUCT TO THE STORE OR SEND IT TO
NORTH CANTON FOR SERVICE.
Assembly
Attach handle
1. Remove bolt and nut from lower handle section (straight tube). Place
lower handle section into socket in polisher base with open end of cord
storage hook down and to rear. Push bolt through small holes and secure
with nut. * Tighten with screwdriver.
2. Remove bolt, nut, and cord clip from upper handle. With cord storage
hook to rear, join upper and lower handle, lining up holes. Place cord clip
around cord with flat side toward handle and holes to the front. Insert bolt
through cord clip and small holes in handle, secure with nut.* Pull up slack
in cord and tighten nut with screwdriver.
*If bolt appears to be too short, it has been inserted through the large holes.
Attach brushes and
pads
Disconnect from electric circuit
before putting on or removing
brushes and pads.
Place polisher upside down on flat
surface.
Press each brush down firmly over
brush shaft, rotating brush until it
clicks into position. To remove
grasp center of brush with thumb
and fingers and lift up .
To attach pads,
insert end of
fastener through opening in pad.
Place pad over brush.
The fastener fits around the brush
shaft. Press fastener to snap pad
into place. Unsnap fastener to
remove pad.
4