Filter
Top Products
2. After plate is removed,
pry out the end section
as shown in illustration.
3.
After plate is removed,
tap the shaft gently with
a hammer.
4. Pull other plate and the
shaft from agitator.
5.
Remove brushes by pull-
ing them from agitator.
If they do not come out
easily,
pull them out
with pliers.
&Install
new brushes by
sliding them into the
channel,
making
sure
that the small end goes
in first. Push in as far
as possible.
7.
Replace end plate and
shaft. Remember to line
up locator with the slot
on the agitator. Replace
other end section and end
plate and then tighten.
13