Filter
Top Products
TO
REPLACE
THROW-
AWAY
BAG
Tip cleaner over,
resting handle on
the floor. @pen bag cover of cleaner
by turning latch in either direction.
Lift bag cover.
Hold throw-away
bag by cardboard cover, twist out-
ward, and remove. Discard used bag.
To attach new throw-away bag, hold
bag with cardboard collar down and
with arrows pointing toward front of
cleaner. Push hole in cardboard
firmly over tube, twisting until bag
is secure.
Be sure that throw-away
bag is not extending outside of cover
and that cover is in proper position
on the gasket before latching.
WHERE
TO
BUY
BAGS
Keep a supply of Throw-Away Bags on hand. They may be
purchased at your local Authorized Hoover Dealer (listed in
in the Yellow Pages of your Telephone Directory under “Vac-
uum Cleaners”
-
Hoover) or from Hoover Factory Branch
Service Stations listed on the service page of this book.
WHEN ORDERING THROW-AWAY BAGS, BE SURE TO MEN-
TION THE MODEL OF YOUR CLEANER.
THE BELT
WHEN
TO
REPLACE
THE
BELT
Remove bottom plate from cleaner
(see Fig,
1)
and check from time to
time to be sure the belt is in good
condition. If it is stretched or cut,
it should be replaced.
10