Hoover 7010 Vacuum Cleaner User Manual


 
Before you Begin
Before you begin
The cleaner must be operated in accordance with these instructions and used only for domestic household
cleaning to remove DRY dirt and dust from household carpets, flooring and fabrics. This cleaner is not fit to
be used as an industrial cleaner, and is not designed for the collection of vitreous building material including
particle board, construction products and similar products such as wood/fibres, cement, fillers, fibre glass
etc or excessive or frequent sand. The infrequent pick-up of these materials in these circumstances may be
harmful to your cleaner and may void the manufacturer’s warranty.
Please read these instructions thoroughly
This will ensure you obtain full benefit from your new cleaner. Keep this Instruction Manual in a handy place
for future reference.
Important
Always switch the cleaner off and remove the plug from the electricity supply before cleaning your
appliance, when not in use, or attempting any maintenance task. The cleaner must only be connected to
an AC supply at the voltage shown on the rating plate. This cleaner should only be used for its intended
purpose as described in these instructions. Never operate the vacuum cleaner without filters.
Before you begin
Precautionary measures:
1. Do not operate the vacuum cleaner too close to heaters, radiators, and other
hot surfaces.
2. Before inserting the plug into the wall, make sure your hand is dry.
3. Before turning on the vacuum cleaner, remove any large or sharp objects from the
floor or cleaning surface in order to prevent damage to the filter.
4. When you want to pull the plug from the wall, do not use the power cable,
gently pull the plug from the power socket.
5.
If the air inlet, floor head or telescopic tube are blocked, you should switch off
the cleaner straight away and remove from mains power. First clear the blocked
substance before attempting to start the vacuum cleaner again.