Filter
Top Products
CARPET HEIGHT ADJUSTMENT
The cleaning of carpet
and rugs takes place at
the nozzle (A).
When it is necessary to
raise and lower the nozzle
for various carpet pile
heights, slide the nozzle
control knob (B) to the
desired setting.
2.8
A
B
HANDLE POSITION
For ease in sliding knob,
the handle should be in
the upright position (C).
The nozzle will not move
into the adjusted position
until the cleaner handle is
lowered to the operating
position (D).
2.9
C
D
SETTINGS
For maximum cleaning performance, the following carpet
height settings are recommended:
• Lowest setting: or all types of carpet. Note: If the
cleaner is difficult to push, slide knob to the next higher
setting.
• Higher settings: for very deep pile carpet where easier
pushing effort is desired, while maintaining good clean-
ing performance.
2.10
HIGH
HARD
FLOOR
8
CLEANING LIGHTWEIGHT
FLEXIBLE RUGS
Stand on one end of rug and move cleaner toward other
end or edge. Before reaching edge, push down on
handle. This will lift up the nozzle (front of cleaner) as
shown and will prevent rug from clinging to cleaner.
Continue to lift up nozzle so that when you have reached
the edge, it is completely off the rug. Move cleaner back
to start again, lower nozzle, and use only forward
strokes.
2.11
2.12
2.12 Lift vacuum by Stair Cleaning Handle and
position on stairs. Clean forward to back. Never leave
the vacuum standing on stairs when not cleaning.
STAIR CLEANING