Filter
Top Products
Installation and Use
69-2108EFS—01 2
Pre-installation setup
Note: Removing the cover also provides access to the nameplate, so now is a good
time to write your name or other information. To use the nameplate, pull the end out
from the side of the battery compartment, add your text at the end of the strip and
carefully push it back into the slot.
2. Insert six AA-size alkaline batteries in the battery
compartment at the back of the door camera – as
in the following diagram. Follow the plus (+) and
minus (–) signs on the diagram inside the battery
compartment. Never mix old and new batteries.
3. Refit the camera base and insert the
screws to stop the tamper alert from
sounding.
Note: There is an option to power the door
camera using an 8–10V transformer. See ‘Door
Camera Transformer option’ at the end of this
section for details.
1
3
2
69-2108EFS_A.indd 2 11/30/2007 1:51:45 PM