Filter
Top Products
VISIOCAM
11 69-2108EFS—01
Expanding your system
There are many ways to expand your entry system: you can connect your system to a
television set or add more cameras, for example.
TV connection
You can connect the receiver to a TV set via the accessory RCA lead provided.
Connect the stereo plug to the VisioCam receiver unit and plug the yellow RCA plug
to the TV AV input. Set the TV channel to the default AV channel for the said RCA
input (refer to TV set instructions).
When the door camera is activated, the VisioCam receiver will chime and the TV will
display the image of the visitor.
Note: The TV needs to be set at the default channel manually in order to display the
image. Auto switching function not available.
Adding a door push
The receiver will respond to a Visiocam door push. To program a door push into the
receiver:
1. Press and hold the ‘ ’ button for approximately five seconds until the receiver
beeps three times
2. Press the door push button until the receiver sounds.
Note: The video receiver does not respond to a door push while the video screen is
active.
Additional door cameras
The receiver will respond to up to four door cameras.
Each camera must be set on a different video channel (1–4), and be programmed
into the receiver. Refer to the instructions provided with the additional unit, or see ‘To
reprogram or reset the receiver’, in this section.
To reprogram or reset the receiver
A. To add another door camera or bell push:
Press and hold the ‘ ’ button for more than five seconds, the unit will beep three times
and enter programming mode for approximately two minutes. During the two minute
programming time, press the call button or button on the new unit to program it in. The
unit must be within 30–60 ft. (10–20 m) of the receiver to ensure reliable programming.
B. To clear all programmed data, e.g. when replacing a door camera:
Press and hold both the ‘ ’ and ‘ ’ buttons in for five seconds to clear the pro-
grammed data and enter programming mode. The available chime sounds play.
Follow the programming sequence under Receiver Setup.
69-2108EFS_A.indd 11 11/30/2007 1:51:49 PM