Hitachi RAS-SX10HAK / RAC-SX10HAK Air Conditioner User Manual


 
TROUBLESHOOTING (continued)
Anti-mold
wasabi cassette
Dust box
ANTI-MOLD WASABI CASSETTE
Anti-mold elements with wasabi aroma prevents mold growth inside the dust box in which the dust collected
by filter cleaning operation is kept. Although only a trace amount of anti-mold elements is released, there may
be wasabi smell in the room depending on the environment in which the air conditioner is used. If you feel this
smell is unpleasant, block one of the anti-mold element outlets with a commercially available adhesive tape. If
this measure is taken, the amount of anti-mold element to be released will be reduced and the anti-mold effect
will also be less accordingly. To prevent mold growth, frequent cleaning of the dust box is recommended.
Outlet (2 places)
The gap made on
the side surface
Block one of the outlets with an
adhesive tape (Either one of 2
outlets)
Do the batteries need replacement?
Is the polarity of the inserted batteries correct?
Is the power plug inserted properly?
Is the fuse blown out or circuit breaker tripped?
Is there a blackout? (Operation remains idle after a blackout.)
Is the micro mesh stainless filter blocked with dust?
Is the set temperature suitable?
Have the vertical air deflector been adjusted to the correct positions according to
the operation mode selected?
Are the air inlets and air outlets of indoor and outdoor units blocked?
Is the fan speed “LOW” or “SILENT”?
Check “filter cleaning operation”.
PLEASE CHECK THE FOLLOWING BEFORE SERVICE
Signal cannot be
received
(Remote controller
display is dim or
blank)
Operation does
not start
Does not cool well
Does not heat well
(CLEAN)
indicator blinks
– 42 –