Hitachi RAS-SX10HAK / RAC-SX10HAK Air Conditioner User Manual


 
3
2
FILTER CLEANING OPERATION (continued)
Manual filter cleaning operation
Use the remote controller to run filter cleaning operation when the air conditioner operation is stop.
before it is initialized.
Press the
(MANUAL CLEAN) button when the air-conditioner stops.
The cleaning unit makes one cycle of back and forth movement to sweep
the dust on the micro mesh stainless filter and the dust catcher puts the
collected dust into the dust box.
One cycle of filter cleaning operation will take approximately 5 minutes.
During manual filter cleaning operation, movable panel and horizontal air
deflectors remain closed when fan operation starts.
STOP
Press the (STOP) button twice.
Press
(STOP) button on the remote controller twice to stop the process
of filter cleaning operation.
Maintenance
(Maintenance, page 34)
HOW TO PROHIBIT THE FILTER CLEANING OPERATION
With the remote controller, you can make a setting in which no filter cleaning operation is
performed.
This setting should be made only when the air conditioner is stopped.
Press the (MANUAL CLEAN) button while pressing the (ON/OFF)
button (remain for 5 seconds).
A double short beep sounds and the filter cleaning is not performed (filter
cleaning operation is prohibited) is set.
If the (MANUAL CLEAN) button is pressed while pressing down
the (ON/OFF) button again (hold the buttons for 5 seconds), a
single short beep sounds and the setting returns to the filter cleaning
operation.
Filter cleaning operation (Normal)
(at time of purchase)
“Beep” sound
Filter cleaning operation
is prohibited
“Beep Beep” sound
If the filter cleaning operation is
prohibited, the operation check (page
10), automatic filter cleaning
operation and manual filter cleaning
operation are not performed.
– 32 –
If the air conditioner is not in use for a long period, it is recommended to manually run filter cleaning
No daily maintenance is required. However, dust amount varies depending on the environment in which
the air conditioner is used. Check the dust amount approximately once every two years and throw the
Greasy dirt can also be cleaned by the combined function of filter cleaning and micro mesh stainless filter. If the
dirt looks heavy, remove the micro mesh stainless filter, dust catcher and filter cleaning wiper to wash them with
water. (Maintenance, page 34~38)
dust, if any.
1
2