Filter
Top Products
— 26 —
English
MAINTENANCE
NOTE:
The information contained in this Manual is designed to
assist you in the safe maintenance of the Nailer.
Some illustrations in this Manual may show details or at-
tachments that differ from those on your own Nailer.
MAINTENANCE AND INSPECTION
Read section titled “SAFETY” (page 4-9)
WARNING
•
Disconnect air hose and remove all nails from Nailer when:
1) doing maintenance and inspection; and
2) clearing a jam.
1. Clearing a Jam
In the event of a jam, the Gate (Ref. No. 22) can be opened by
unscrewing the two Gate Screws and releasing the Gate. (See
Figures 1 and 2) (The Shoe does not have to be removed to
remove and replace the Gate.) Follow instructions below.
IMMEDIATELY DISCONNECT from power source until jam is
cleared!
Remove all Nails in the Magazine.
DO NOT PRY OPEN THE GATE. Unscrew the Gate Screws 1-2
turns. Lift and pull the Gate downward as shown and remove
the Gate from over the Screws through the slots in the Gate as
shown in Figure 1.
Figure 1