Filter
Top Products
— 24 —
English
The NT50AF Pneumatic Flooring Nailer and N5009AF Pneumatic
Flooring Stapler have a safety trigger that prevents accidental op‑
eration if ram cap is hit while connected to power source. Squeeze
safety lever to enable the Tool. Releasing the safety lever re‑engag‑
es the safety and renders the Tool inoperable.
To operate Tool, depress safety trigger while Tool is in position of
use, and tap the ram cap with a minimal stroke from the hammer.
If on the first initial operation a fastener does not eject into the
flooring, repeat hammer blow. This will ensure that the driver
blade/Piston is properly reset to allow the driver blade/piston to be
in the correct position to drive the fastener.
DO NOT OVERPOWER THE TOOL– A 90lb static force will oper‑
ate the Tool. This is easily achieved by a tap of the Hammer. If the
Flooring is warped or bowed, the ram can be hit firmly to tighten
the flooring. Try to avoid this constant wear, as abusive blows by
the hammer could damage tool and / or internal parts.
DO NOT HIT THE TOOL HARD
This Tool is pneumatically powered and requires only actuation by
depressing the safety trigger and tapping the ram head.
Note: The NT50AF Pneumatic Flooring Nailer and N5009AF Pneu‑
matic Flooring Stapler will not drive a fastener if the ram cap is
struck by hammer and the safety trigger is not depressed.
The NT50AF Pneumatic Flooring Nailer and N5009AF Pneumatic
Flooring Stapler are user‑friendly and following these simple
instructions, will insure a very high quality hardwood flooring
installation.
If the fastener is not properly seated, increase pressure incremen‑
tally until fastener is seated. DO NOT EXCEED 90 PSI!
WARNING
•
Keep your finger off the trigger except during fastening opera-
tion, because serious injury could result if the contact ram
accidentally contacts you or others in the work area.
•
Keep hands and body away from the discharge area. The Tool
may bounce from recoil of driving a fastener and unwanted
subsequent fastener may be driven, possibly causing injury.
•
Some types of loaded fasteners can spark out of the muzzle
during a driving operation. Exercise caution!