Filter
Top Products
FP USER INSTRUCTIONS ENGLISH 71576286 - 07/06
Page 25 of 35
6.3.2 Storage of spares
Spares should be stored in a clean dry area away
from vibration. Inspection and re-treatment of
metallic surfaces (if necessary) with preservative is
recommended at 6 monthly intervals.
6.4 Recommended spares and
consumable items
50 FP, 65 FP, 80 FP, 100 FP, 125 FP: [2250] -
[3011-01] - [3011-02] - [4130] - [4590] - [4610]
122 FP, 152 FP, 202 FP: [2250] - [3011-01] - [3011-
02] - [4130] - [4590-01] - [4590-02] - [4610-01] -
[4610-02] - [4610-03] - [4610-04]
a) Destroy all the gaskets after dismantling, replace
them when reassembling.
b) IT IS RECOMMENDED THAT
BEARINGS ARE NOT REUSED AFTER ANY
REMOVAL FROM THE SHAFT.
c) After serving during two years, replace the gland
packing.
6.5 Disassembly
Refer to section 1.6, Safety, and section 6
Maintenance, before dismantling the pump.
Before dismantling the pump for
overhaul, ensure genuine Flowserve replacement
parts are available. Refer to sectional drawings for
part numbers and identification.
REPAIR OF THE PUMP
If the pump presents abnormalities or a
persistent malfunction, contact immediately:
FLOWSERVE
After-sales Service
Tel.: 02 43 40 57 57
(33) 2 43 40 57 57
Fax.: 02 43 40 58 17
(33) 2 43 40 58 17
According to the After-sales Service instructions,
disassembly will be limited to the dismantling of the
pump:
a) DISCONNECT THE UNIT FROM
POWER.
b) Close the inlet valve (if fitted) and outlet valve.
c) Wait for the moment when the pump casing is
cooled and at ambient temperature.
d) DRAIN PUMP.
e) Dismantle inlet and outlet pipeworks as well as
all pipeworks.
f) REMOVE PUMP TAKING INTO
ACCOUNT SAFETY (§ 1) AND HANDLING
(§ 2.2) PROCEDURES.
ANY DISASSEMBLY, REPAIR OR
REASSEMBLY WILL BE CARRIED OUT UNDER
FLOWSERVE' RESPONSABILITY, EITHER
DIRECTLY BY THE AFTER-SALES SERVICE OR
BY OTHER FLOWSERVE-AGENTS WHO WILL
GET THE REQUIRED INSTRUCTIONS AND
APPROVALS. THIS IS THE CASE OF
AUTHORIZED REPAIRERS WHOSE ADDRESSES
AND TELEPHONE NUMBERS WILL BE GIVEN
ON REQUEST.