Filter
Top Products
HP ProLiant Essentials Rapid Deployment Pack—Windows Edition Support Matrix 17
Microsoft Windows Server 2003
Microsoft Windows Server 2003, Standard Edition, Enterprise Edition, and Web Edition are
supported. These operating systems can be deployed to the platforms listed in Table 9.
IMPORTANT: If you plan to perform scripted installations with PXE, refer to Table 4 for important
firmware prerequisites. HP strongly recommends that you use the default UNDI driver in your PXE boot
images (instead of the NDIS2 driver).
Table 9: Platforms Supporting Microsoft Windows Server 2003 Deployment
ProLiant BL10e
2
ProLiant DL380 ProLiant ML330 G2 (ATA)
ProLiant BL10e G2
2
ProLiant DL380 G2 ProLiant ML330 G2 (SCSI)
ProLiant BL20p ProLiant DL380 G2 Packaged Cluster ProLiant ML330 G3 (ATA)
ProLiant BL20p G2 ProLiant DL380 G3 ProLiant ML330 G3 (SCSI)
ProLiant BL20p G3 ProLiant DL380 G3 Packaged Cluster ProLiant ML350
ProLiant BL25p ProLiant DL380 G4 ProLiant ML350 G2
ProLiant BL30p ProLiant DL380 G4 Packaged Cluster
ProLiant ML350 G3
ProLiant BL35p ProLiant DL385 ProLiant ML350 G4
ProLiant BL40p ProLiant DL560 ProLiant ML350 G4p (SATA) NEW
ProLiant BL45p NEW ProLiant DL580 ProLiant ML350 G4p (SCSI) NEW
ProLiant DL140
1
ProLiant DL580 G2 ProLiant ML370
ProLiant DL145
1
ProLiant DL580 G3 NEW ProLiant ML370 G2
ProLiant DL320 G2 (ATA) ProLiant DL585 ProLiant ML370 G3
ProLiant DL320 G2 (SCSI) ProLiant DL740 ProLiant ML370 G4
ProLiant DL320 G3 (SATA) ProLiant DL760 ProLiant ML530
ProLiant DL320 G3 (SCSI) ProLiant DL760 G2 ProLiant ML530 G2
ProLiant DL360 G2 ProLiant ML310 (ATA) ProLiant ML570
ProLiant DL360 G3 ProLiant ML310 (SCSI) ProLiant ML570 G2
ProLiant DL360 G4 (SATA) ProLiant ML310 G2 (SATA) ProLiant ML570 G3
ProLiant DL360 G4 (SCSI) ProLiant ML310 G2 (SCSI) ProLiant ML750
ProLiant DL360 G4p (SATA) NEW ProLiant ML330 VMware ESX Server 2.5.1 virtual
machine
ProLiant DL360 G4p (SCSI) NEW ProLiant ML330e
1
Only image install is supported.
2
A scripted install can sometimes hang either at the end of the blue screen setup or after completing the NTFS file
system conversion. Manually reboot the blade to allow setup to continue normally.