Filter
Top Products
11
Fig. 5
Fig. 6 Fig. 7
5. Remove the three (3) screws that hold the fan motor in place.
6. Slowly pull the motor and fan wheel out from the back of the heater.
7. Look between the fan wheel and the end of the motor and locate the notches referenced
above in item 3.
8. Put six (6) drops of oil in the notch at each end of the motor.
9. Replace the motor with the brackets in the same location as they were
mounted at the factory.
10. Replace the fan cover on the back of the heater.
11. Plug the heater back into the electric wall outlet.
NATURAL GAS PROPANE GAS
DiamondGlo Jr. DiamondGlo II