Filter
Top Products
63Heatilator • Novus NNXT • 4055-879 • Rev. o • 2/12
Q. Install Hood
• Locate the four screws just inside the upper section of
the appliance.
• Slide the hood into position uncer the screw heads.
• Tighten the four screws. See Figure 15.16.
P. Unpackage the Hood & Floor Cover
Remove parts package from appliance as shown in Fig-
ure 5.15.
Figure 15.5 Removing Parts Package
Figure 15.16 Intalling Hood
O. Remove Screen Protector
• Cut the tape on top of the screen protector. See
Figure 15.13.
• Open the screen protector and remove the screen. See
Figure 15.14.
Figure 15.14 Remove Screen Protector
Figure 15.13 Cut Packaging Tape
R. Install Control Heat Shield
The control heat shield shipped in the bottom of the ap-
pliance MUST be placed over the control plate before
operating the appliance. Not doing so may result in over-
heating the controls on the plate.
Install the Control Heat Shield
• Locate control heat shield (see Figure 15.17) and remove
from appliance.
Control Heat Shield
Figure 15.17 Locate Control Heat Shield