Filter
Top Products
Heatilator • Novus NNXT • 4055-879 • Rev. o • 2/1262
Figure 15.10 Instell Right Middle Log
• Install the Right middle log by aligning the slot and hole
in the bottom of the log with the two pins on the right
end of the left bottom log.
Figure 15.11 Install Top Right Y Log
• Install the top right Y log by aligning the slot on the bottom
of the log with the pin on the right side of the back log.
The Y end of the log should rest on the top indent in the
right middle log and the top of the right bottom log.
M. Replacing Fixed Glass Assembly
• Set the glass panel on the lower two or four glass
assembly latches, ensuring the glass panel is centered
in the opening.
• Replace glass latches. See Figure 15.4.
N. Air Shutter Setting
Air shutter setting should be adjusted by a qualifi ed in-
staller at the time of installation.
• The air shutter is set at the factory for minimum vertical
vent run.
• Adjust air shutter for longer vertical runs. See
Figure 15.12.
• Turn the thumbscrew to open and close.
OpenClose
Figure 15.12 Adjusting Air Shutter