Heath Zenith 598-1127-03 Door User Manual


  Open as PDF
of 24
 
-5-
598-1127-03
3.Tochangethecode,either:
• Addajumpertothesamelocationonboththepushbuttonandthechime
or...
• Removeajumperfromthesamelocationonboththepushbuttonandthe
chime or...
• Moveajumperonthepushbuttonfromonelocationtoanother.Movethe
correspondingjumperonthechimetomatchthenewlocationinthepush
button.
Example:Movejumperatlocation“1”tolocation“2”onboththepush
button and the chime.
Note:

Note:Unitwillcomefactorysetwithjumpersinlocations1,2,and3onthe
pushbuttonandonthechime(seeFigure7).
Therangeofthewirelesschimecanvarywithlocation,temperature,and
battery condition.
*CodeSettings1-3
Must Match Both Push
ButtonandChime
Inside Push
Button
InsideChime
Note: Some models might require the use
oftweezerstoremoveandreplacethe
jumpers.
Figure 7
123
AB C 1 2 3
 previous next